Bartlett
Driveways and business lots where oxidation and crack repair are usually the first things to address.
Serving Memphis, Tennessee & surrounding areas
Mon–Fri 8am–6pm · Sat 9am–2pm
Memphis asphalt protection
Protect your asphalt from sun, rain, oil drips, and everyday wear with a clean, even seal coat that keeps pavement looking sharp and lasting longer.
Protect before repairs grow
Sealcoating is the protective layer that helps your asphalt resist oxidation, moisture intrusion, and surface raveling. In Memphis, hot summers and heavy rain cycles can speed up fading and cracking, especially on drive lanes, parking pads, and turn-around areas that take the most traffic.
Sealcoating Memphis focuses on practical results: solid surface prep, clean application, and clear cure-time guidance so the finish sets up the way it should. If your pavement is gray, drying out, or absorbing water instead of shedding it, asphalt sealing in Memphis can be a smart maintenance step before small issues become repairs.
Beyond Memphis city limits
We work across the Memphis metro from our location on Doctor M.L.K. Jr Ave, covering these communities for sealcoating, crack repair, patching, and striping. Each page explains what pavement in that area typically needs.
Driveways and business lots where oxidation and crack repair are usually the first things to address.
Longer drive approaches, which means more square footage and more seams where water can reach the base.
Residential and commercial pavement across the state line in Mississippi, covered from the same Memphis base.
Larger lots and long drive approaches, where seam sealing matters as much as the coat itself.
Properties where timing decides the cost, since maintenance while a surface is sound beats repair later.
Complete pavement care
Sealcoating is one part of keeping asphalt intact. These are the other services we run, and most properties end up needing two or three of them together.
New asphalt installation and resurfacing for driveways and paved areas, with proper base prep and compaction for a smooth, durable surface.
Residential driveway sealing focused on neat edges, uniform coverage, and a finish that improves curb appeal while protecting the surface.
Commercial seal coating programs for lots that need consistent appearance, protected pavement, and minimal disruption to tenants and customers.
Hot or cold crack filling, as conditions allow, to help keep water out and slow the spread of cracking across asphalt surfaces.
Targeted asphalt repairs for failed edges, low spots, and damaged sections to restore function and improve the way water drains off the pavement.
Parking stall striping, directional arrows, and fire lane markings laid out for clear traffic flow and a professional look.
Workmanship at every edge
The difference between a coat that lasts and one that does not is mostly in the preparation, so that is where most of this list sits.
We clean the surface and address problem areas first, because sealcoat applied over dirt, loose aggregate, or failing asphalt will not last.
Edges at sidewalks, garage aprons, and curbs are handled carefully so the finished job looks intentional, not sloppy.
High-wear areas like turning radiuses and the first few feet at the street get the attention they need for an even, consistent finish.
We plan around access so you know when to stay off the surface and when it is ready for foot and vehicle traffic.
If the asphalt needs crack sealing or repairs before sealing, we explain why and what to do first so you do not pay for a short-lived coat.
Based in Memphis
Sealcoating Memphis is a local crew based in Memphis, Tennessee. You can find us at 691 Doctor M.L.K. Jr Ave, Suite 4, Memphis, TN 38126.
We take a contractor-first approach to Memphis sealcoating: show up prepared, evaluate the pavement condition, and lay out a clear scope that matches what the asphalt actually needs. That means talking through surface wear, drainage, and any cracking we see, then recommending the right order of work so the seal coat performs.
Whether you are maintaining a home driveway or managing a property with asphalt surfaces, you should know what is being applied, what prep is included, and how long the surface needs to cure. That is the kind of straightforward communication we bring to every job.
Condition-based pricing
Sealcoating in Memphis typically ranges from about $0.20 to $0.45 per square foot for most residential and light commercial projects. A standard single-car driveway often lands around $250 to $450, while larger driveways or small lots commonly run $500 to $1,200+ depending on layout and condition.
Your final price depends on surface area, crack density, oil spot prep, accessibility, edging detail, and whether repairs are needed before coating. Exact pricing is confirmed after an on-site look at the asphalt so the scope matches the pavement.
From inspection to access
A durable finish starts with understanding the pavement, preparing it correctly, and giving the coating time to cure.
We look at pavement condition, drainage, and traffic patterns, then outline what prep and protection the surface needs.
We clear debris, treat problem areas, and prep edges so the sealcoat bonds and finishes cleanly.
Sealcoat is applied evenly with attention to drive lanes, turns, and transitions at concrete.
We set expectations for when the surface can be walked on and when vehicles can return, based on conditions that day.
If you want your pavement protected without guessing what prep is included, we can provide a written scope and a clear plan before any work starts.
Call for a Free EstimateLocal planning matters
We provide sealcoating across Memphis, with a lot of our work concentrated in neighborhoods where driveways and private lanes see regular sun exposure and storm runoff.
Book Your Free InspectionEast Memphis: Many homes have wider driveways and turn-arounds where tire wear and oxidation show up first.
Midtown, including Cooper-Young: Older properties often have mixed pavement sections and patch history.
Germantown: Larger lots and longer drive approaches can mean more square footage and more seams to protect from water.
Cordova: Subdivision driveways commonly get frequent vehicle traffic, especially near the garage and street.
Whitehaven: Shade patterns and runoff can create uneven weathering across driveway surfaces.
Downtown Memphis: Tight access and shared parking call for careful staging and clear cure-time planning.
Surface, edge, and finish
Photographs from recent driveway and parking lot jobs around Memphis, showing the finish and the edge work up close.
Practical answers
Understand surface condition, preparation, access, and cure time before scheduling your project.
If the surface is turning gray, feels rough, or absorbs water instead of shedding it, it is often a good candidate for sealcoating. If there is widespread cracking, crumbling edges, or soft spots, repairs and crack sealing may need to happen first so the seal coat is not applied over failing areas.
Most sealed asphalt needs at least a full day before vehicles return, and longer can be better in humid or cooler conditions. We give cure-time guidance based on the day's weather and the site's shade and airflow, since those factors affect how quickly the coating sets.
Sealcoat can cover and protect patched areas, but cracks should be addressed first when they are open or spreading. A sealcoating contractor in Memphis should treat cracking as a water-entry problem, because sealing over it without prep usually leads to faster failure along the crack lines.
We mainly need the pavement cleared of vehicles and any items sitting on the asphalt, plus access to the full area being coated. If there are gates, shared drives, or parking constraints, we sort out a plan ahead of time so the job can be completed in one continuous application.
Yes, back-to-back driveways are often efficient to schedule together if both areas are ready and can be kept clear during cure time. It also helps when the two properties share a drive apron or have tight access where staging matters.
Yes, we handle residential driveways and commercial asphalt surfaces, and we adjust planning based on traffic patterns and access. Commercial sites often need more staging detail so vehicles and pedestrians can move safely while the seal coat cures.
Plan the work with confidence
Tell us what you are sealing and what condition it is in. We will recommend the right prep, outline cure-time expectations, and provide a straightforward scope for your asphalt sealing in Memphis.
Request a quote
Send the size and condition and we will come look at it, then put a written scope and price in front of you.